Your Stickuino kit should contain the following. Please check the contents immediately after acquiring your kit. Should anything be missing, contact the lecturer of the embedded systems and sensors assignment. Warning: do not mix the contents of this kit with the Interaction technology sensor kit (another pink bag) that you acquired at the same time, as they both contain similarly looking but functionally very different components!

1 * Stickuino printed circuit board (pcb)
2 * Resistor, 220Ohm
1 * Resistor, 10kOhm
1 * Diode, 1N4007
1 * LED, 3mm, red
1 * LED, 3mm, green
1 * IC socket, 28 pins
1 * Voltage regulator, 7805, 5V
5 * Ceramic capacitor, 0.1uF
1 * Print push button
1 * Voltage regulator, MCP1700, 3.3V
2 * Electrolytic capacitor, 47uF
1 * Resonator, 16MHz
2 * Header, female, straight, 6 pins
2 * Header, female, straight, 8 pins
2 * Header strip for ICSP, male, straight, 3 pins
1 * DC connector
1 * Header strip, male, straight, 6 pins
1 * Microcontroller, ATMega328 with Optiboot bootloader

Moving on

When you are sure that you have everything that you need, you can start soldering.